Wire Brush Head – Clears Paving Joints Down to the Stone

A steel wire head that swaps onto an electric trimmer in place of the line spool. It digs moss, weeds and packed dirt out of the gaps between paving stones. The working face is 12.5 x 1.6 cm, narrow enough to follow an edge along a wall or a kerb.

Why choose this wire brush head?

Nylon line takes the green off the top and leaves the root sitting where it was. Steel wire reaches into the joint and pulls the whole plant with it. Once the path is done the same head handles rust, flaking paint and burrs on metal.

Joint depth: Wire gets into the gap rather than skimming across the surface of it.
Carbon steel bristles: One head lasts a full path without a mid-job swap.
Integrated plate: Seats flat on the shaft and holds true at working speed.
Second life indoors: Deburring, rust removal, paint stripping and polishing all use the same head.
Steady grip: Stays controllable when the wire bites on stone and tries to skip.

One pass along the path instead of an afternoon on your knees.

Unplug the machine before fitting the head and check that the plate is flush against the shaft. Run along the joint rather than across it and let the wire cut rather than pushing down on it. Wear eye protection, since steel throws grit a lot further than nylon does.