Shower Threshold Strip – The Water Stops Where the Tile Changes

A soft silicone run that bonds to the floor along the open edge of a shower and holds the runoff on one side. It curves, so a rounded enclosure or an open walk-in is no obstacle. Lengths of one and two meters, in white, black or gray.

Why choose this shower threshold strip?

Water crossing the room is a slip hazard first and a grout problem second. A low dam keeps it contained without building a step that has to be climbed. Installation takes about ten minutes and needs nothing from the toolbox.

Tools stay in the drawer: position it, press it down, nudge it straight before the adhesive grabs.
Flexible run: follows a curve, turns a corner, finishes at an open edge.
Sits low: flat enough that you walk over it without registering the step.
Silicone lip: presses against the tile and keeps the runoff on the wet side.
Six combinations: one or two meters in white, black or gray.

The rest of the floor stays dry and the mop stays put away.

Measure the open span before ordering and allow a little extra rather than joining two pieces. The tile has to be clean and fully dry, and the strip goes down along its whole length without being stretched. Give the adhesive a day to cure before the first shower runs.