Film guards that take the key marks meant for the paint behind a handle

Each patch is cut to drop straight into the dish behind a car door handle, the spot fingernails and key rings reach every time the door opens. The pieces measure 8.5 x 6.8 cm and lift off later without leaving adhesive behind. A set of four covers one car; a set of eight leaves you spares.

Why choose these handle cup guards?

That recess is the one panel on a car that gets worked on daily, and clear coat gives up there long before it does anywhere else. A film patch is the cheap layer that wears instead. Peeling off a scuffed patch and applying a fresh one costs a few minutes and almost nothing.

Cut to shape: fits a standard handle recess straight out of the pack, no knife needed.
Woven finish: a carbon-look weave that reads as trim rather than as a patch job.
Clean lift-off: comes away without residue when you change color or sell the car.
Broad fit: suits most hatchbacks, sedans and SUVs.
Four or eight per set: one car covered, or a second set held back for later.

Thirty grams of film standing between a key ring and a respray.

Clean and dry the recess before you start, and on a cold morning warm the panel a little so the adhesive grabs. Pull the backing away halfway, place the top edge, then press downward with a thumb to drive the air out ahead of the film. Leave the car unwashed for a day so the bond can settle properly.